Vaporesso GTi replacement coils are the mesh coils that drop straight into a compatible tank in place of a spent coil, supplied five to a pack across four resistances.
What sets the GTi coils apart
The mesh structure here is tuned squarely for direct-to-lung vaping: a wide heating surface that comes up to temperature fast, so the draw lands warm and dense and carries the detail of whatever e-liquid is in the tank, instead of the dull or scorched note that creeps in once a coil is past its best.
Wide mesh heating surface for denser vapour and cleaner flavour
Drops into a compatible tank in place of the old coil
Five coils per pack, so there is always a spare at home
Four resistances spanning 30W to 90W, picked to match your device
Available resistances and how to choose
0.15ohm at 75-90W. The most powerful of the four, for high-wattage devices and big vapour.
0.2ohm at 60-75W, which is the range printed on the pack shown in the product photo.
0.4ohm at 50-60W. A balanced pick for everyday vaping.
0.5ohm at 30-40W. The gentlest of the set and the easiest on battery and e-liquid.
Device compatibility
Vaporesso iTank and iTank 2, Target 100 and Target 200, GEN 200, GEN 80S, GEN SE and GEN Max, plus Armour Max, Armour S and Armour Ultra.
Who it suits
Anyone with one of the devices above who wants genuine factory spares, and particularly vapers who keep a pack in the drawer so a dead coil never catches them out at a bad moment. It also suits anyone running high wattage who needs a low resistance that holds up consistently at that level. Fill the tank, give the mesh a few minutes to wick before the first puff, and set your wattage inside the range for your resistance.
Order Vaporesso GTi coils from Sahba Vape. For adult use only.
Fit the coil into a compatible tank in place of the old one
Set the wattage within the range listed for that resistance
Let the filled tank stand a few minutes so the mesh wicks fully before the first puff
Replace the coil when flavour drops off or turns burnt
Storage
Keep the pack in a dry place away from direct sunlight and high temperatures
Leave each coil in its wrapper until it is fitted
Package contents
5 x Vaporesso GTi mesh coil
The coil decides flavour, vapour and how long the setup stays good. A pod has to match your exact device model — visually similar is not the same as compatible.
Before you order
Model — Confirm the device name and generation. Brands sell different pods for different devices under the same family name.
Resistance — The Ω figure sets the draw: higher resistance suits MTL, lower resistance suits open DTL.
Wattage range — It is printed on the coil itself. Stay inside it and the cotton will not scorch.
Mesh or wire — Mesh heats evenly and generally gives cleaner flavour and a longer life.
Fitting a coil properly
Prime it — Wet the cotton ports with a few drops of e-liquid before fitting.
Let it rest — Fill, then leave it standing for 10 to 15 minutes.
Ramp up — Start at the bottom of the wattage range and climb gradually.
When to replace
Flavour drop — The first signal that a coil is on its way out.
Burnt taste — The cotton is damaged — replace it straight away.
Gurgling or leaking — A sign the coil is no longer wicking properly.
Reviews
There are no reviews yet.