GeekVape P Series replacement coils are the genuine mesh coils for the P range, supplied five to a pack in four resistances so you can match the coil to the wattage you actually vape at.
What sets the P Series coils apart
Every coil in the range is built around a KA1 mesh strip wrapped in organic cotton. Mesh spreads the heat evenly across the whole surface instead of concentrating it in one spot, so the e-liquid you fill tastes clean from the first puff and holds that level far longer before the coil starts to fade.
KA1 mesh wire with organic cotton for even heating and balanced flavour
Organic cotton rewicks quickly, so chain vaping does not drop off halfway through a session
Press-fit installation with no threading and no tools, swapped in seconds
Five coils per pack, so a spare is always on hand
Four resistances covering a wide 40W to 85W window
Available resistances and how to choose
0.15ohm at 70-85W. The most powerful of the four and the biggest on vapour, for high-wattage setups.
0.2ohm at 60-70W. Warm, dense clouds without getting through e-liquid too quickly.
0.4ohm at 50-60W. The comfortable middle ground for everyday use.
0.5ohm at 40-50W. The easiest of the range on both battery and e-liquid.
Device compatibility
GeekVape Aegis Boost Pro, Boost Pro 2, E100, E100i, B100 and Obelisk 60. The whole series is tuned for direct-to-lung (DTL) vaping, so if you are after a tight MTL draw this is not the range for you.
Who it suits
Anyone running a GeekVape P Series device who wants genuine factory spares instead of unbranded alternatives, and especially vapers who like switching resistances depending on the wattage they feel like running that day. Always start at the bottom of the stated range for your resistance and climb slowly until the draw feels right.
Order GeekVape P Series coils from Sahba Vape. For adult use only.
Prime the cotton ports with e-liquid before fitting the coil
Let a new coil soak in a filled tank before the first puff
Start at the lowest wattage in the range for that resistance and raise it gradually
Replace the coil when performance drops or the flavour turns burnt
Storage
Keep each coil in its sealed sachet until it is needed
Store in a dry place away from direct sunlight and high heat
Package contents
5 x GeekVape P Series mesh coil
Before and after you fit it
The coil decides the flavour, the vapour and how long your setup stays good. Before fitting GeekVape P Series Replacement Coils, make sure it matches your exact device model, not just a similar-looking one. One brand can make different pods and coils for different generations of the same device.
Match the model name and generation on your device to the pod or coil before fitting.
For a coil or an empty pod, put a few drops of e-liquid on the cotton ports first.
Fill to the max line and let it stand for 10 to 15 minutes so the cotton soaks through.
Prefilled pods are ready to go: click them firmly into place and start.
Make sure the coil is fully seated to avoid leaks.
Begin at the lowest wattage in the coil's range and increase gradually.
When to replace a pod or coil
A drop in flavour is the first sign a coil is on its way out.
A burnt taste means the cotton is damaged, so swap it straight away.
Gurgling or leaking suggests the coil is no longer wicking properly.
Dark, heavily sweetened e-liquids and high wattage shorten coil life.
Rinsing a coil will not revive it, because saturated cotton does not recover.
The right resistance depends on how you draw. If you are unsure whether you vape MTL or DTL, this explainer settles it.
How do I check that GeekVape P Series Replacement Coils fits my device?
Go by the model name and generation printed on your device or its original box. A similar shape is not enough, because connection dimensions change between generations even within one family. If you are still unsure, get in touch and mention your device model.
What does the ohm number on a pod or coil mean?
It is the coil's resistance. Higher ohms give a tighter draw and less vapour, which suits salt nicotine and MTL vaping, while lower ohms give an open draw and more vapour for freebase e-liquid. The details are in Vape Coils Explained — Ohms, Lifespan and When to Change Them.
Do Geekvape pods and coils fit other devices?
As a rule, a pod or coil fits only the devices named in its title or on its box. Some coils are shared across several devices in the same series, in which case the compatible devices are listed in the name. Never go by looks alone, and you can browse the devices themselves in pod systems.
How long does GeekVape P Series Replacement Coils last?
It depends on how you use it. Dark, heavily sweetened e-liquids and high wattage shorten coil life, while lighter flavours and moderate power extend it. A prefilled pod is done when its e-liquid runs out, and a coil should be replaced as soon as the flavour drops or tastes burnt. See what burns your coil.
Why does a brand new coil taste burnt?
Usually the cotton was not primed long enough before the first puff, or the wattage is above the range printed on the coil. Drip e-liquid onto the cotton, let it stand after filling, and start at the lowest wattage. Other causes are covered in Common Mistakes That Burn Your Coil and Ruin the Flavour.
Picked GeekVape P Series Replacement Coils? It belongs to the Geekvape world of pod kits and box mods. We also stock replacement pods, coils and drip tips for its devices.
Geekvape makes vape hardware, from compact pod kits to full box mods. From the Wenax series we carry the Wenax M, M2 and Q2 kits, K1, M1, Q and S3 replacement pods, and filter drip tips for Wenax devices.
For mod users there's the E100 kit and the Legend 5 from the Aegis series. Coils include the P Series and the Z Series, which fits Zeus and Aegis Legend tanks.
Matching Geekvape gear to your vaping
Want a small MTL device? Start with the Wenax kits.
Prefer DTL? Look at the E100 or Legend 5.
Own a Wenax device? Make sure the replacement pod matches your model: K1, M1, Q or S3.
Replacing coils? Match the coil to your tank; the Z Series fits Zeus and Aegis Legend tanks.
Products from Pods & Coils are ordered through WhatsApp. After your GeekVape P Series Replacement Coils order is confirmed, the driver brings it to your door.
How to order: WhatsApp only, on +965 55727313.
Delivery time: usually one to two hours from order confirmation.
Coverage: every governorate — Capital, Hawalli, Farwaniya, Jahra, Ahmadi and Mubarak Al-Kabeer.
Delivery fee: varies by area; customer service confirms it when you order.
Remote areas: chalets and farms such as Sabah Al-Ahmad, Wafra, Abdali and Khiran are covered at a special rate.
Payment: cash on delivery, KNET, Wamd, payment link, Visa and Mastercard.
Hours: daily from 8 am to 4 am.
Receiving: the recipient must be 21 or over, and the driver may ask for a civil ID.
If you need to exchange or return
Window: 14 days from the date of purchase, under Kuwait's consumer protection law.
Conditions: the original invoice or order number, the product sealed in its original wrapping and unused, and packaging free of tears or scratches.
Our mistake: if you receive the wrong item or a clear manufacturing defect, the store covers the full cost of the exchange and delivery.
Change of mind: to exchange or return an intact item that matches your order within the 14 days, you pay the courier's return fee.
E-liquids, pods and coils cannot be returned or exchanged once unsealed, and that includes GeekVape P Series Replacement Coils.
For an exchange or any question about your order, message us on WhatsApp at +965 55727313 with your order number, a photo of the product and the invoice. The store is in Salmiya, Salem Al-Mubarak Street, Amar Plaza.
Sahba Vape ships to Saudi Arabia through specialised shipping companies. Order GeekVape P Series Replacement Coils on WhatsApp and we arrange the shipment.
Transit time: usually 3 to 5 working days, depending on the city and customs clearance.
Shipping fee: set by the weight and size of the shipment.
Customs: shipments may be subject to customs duty or VAT under Saudi rules, paid by the customer on receipt.
Tracking: you get a WhatsApp or email notification as soon as the shipment leaves.
Reviews
There are no reviews yet.